Skip to content

FREE SHIPPING (Orders Over $150)

FREE SHIPPING (Orders Over $150)

FREE SHIPPING (Orders Over $150)

How to Mop With a Concentrate: Dilution for Tile, Vinyl Plank, Laminate & Sealed Hardwood

Quick Summary

Diluting a Concentrated Floor Cleaner

  • The short answer: The right dilution depends on your floor. Start with your flooring maker's care guide, then measure, test in a hidden spot, and mop damp, never wet.
  • Advanage's published floor mix: 20:1 (water to concentrate) for tile and linoleum, followed by a rinse. The lightest mix on Advanage's chart is 32:1.
  • Mop-water math: At 20:1, that is 6.4 ounces of concentrate per gallon of water, about $4.76 per mixed gallon from a gallon jug. At 32:1, it is 4 ounces per gallon, about $3.03.
  • Vinyl plank: Makers specify pH-neutral cleaners at label dosage and warn against steam, wax, vinegar, and oil soaps.
  • Laminate: Keep the mop barely damp, use a maker-approved cleaner, and dry as you go.
  • Sealed hardwood: The National Wood Flooring Association says not to wet-mop or steam-mop, so use the cleaner your finish maker recommends.
  • Streaks: They almost always come from too much cleaner, dirty mop water, or skipping the rinse.
  • The setup: ADVANAGE 20X Lavender (quart $39.95, gallon 99.95)plustheMicrofiberMop&HighDusterset(59.95).

How to Mop With a Concentrate: Dilution for Tile, Vinyl Plank, Laminate & Sealed Hardwood

Nov 11, 2026

Mop day should not feel like a chemistry exam. You pour something into a bucket, push a mop around, and hope the floor looks better when it dries, not hazy or sticky. With a concentrated floor cleaner, the pour is the part that matters most, because a concentrate does exactly what the ratio tells it to do. Too little and the floor stays dirty. Too much and it leaves a film that shows every footprint.

This guide shows how to dilute ADVANAGE 20X Lavender for each common floor type: tile, vinyl plank, laminate, and sealed hardwood. It starts with the rule that matters most, which is that your flooring maker's care guide comes first, then gives you Advanage's published floor mix, the math for a bucket and a spray bottle, a streak troubleshooter, and a microfiber mop method you can repeat every week. 

For the basics of mixing any concentrate, our walkthrough on how to dilute a concentrated cleaner is a good companion.

How Do I Correctly Dilute Concentrated Cleaner for Floors?

Three rules cover almost every floor:

  1. Read the floor's care guide first. The company that made your floor knows its finish. If it names an approved cleaner or a pH range, that comes before any other advice, including ours.

  2. Measure, never eyeball. A concentrate works at a specific ratio. A mixing applicator or a measuring cup removes the guesswork, and it prevents the double-strength habit that leaves floors cloudy.

  3. Start light, then mop damp. Begin with the lightest mix that does the job, apply it to the mop pad rather than flooding the floor, and rinse where the chart calls for it.

For tile and linoleum, Advanage's Cleaning Tips chart gives a clear answer: use a 20:1 dilution of ADVANAGE 20X to clean floors, then rinse, with a non-abrasive pad for tough stains. The chart's lightest mix is 32:1, which it uses for glass and mirrors. Its 2:1 wax-stripper mix is a separate job, and the chart cautions against using it on no-wax floors.

Floor-by-Floor Dilution Guide

Floor

What makers and associations say

ADVANAGE 20X starting point

Moisture

Ceramic, porcelain, and other tile

Sturdy, and grout benefits from a non-abrasive pad on tough spots

20:1, then rinse

Mop, then a clean-water rinse

Linoleum

Follow the sheet maker's guide

20:1, then rinse. Do not use the 2:1 stripper mix on no-wax floors

Damp mop and rinse

Vinyl plank (LVP, LVT)

Armstrong specifies a pH-neutral cleaner at recommended dosages, and Engineered Floors lists vinegar, soap-based detergents, oil soaps, and wax as products to avoid

Only if your maker's guide allows a general cleaner: test first, then 32:1

Damp, no steam

Laminate

EGGER advises avoiding excess water and steam on standard laminate, and a flooring library notes that the manufacturer is the primary source for care

Only if your maker's guide allows: test first, then 32:1 on the pad

Barely damp, dry as you go

Sealed hardwood

The National Wood Flooring Association says not to use wet mops or steam mops

Use your finish maker's recommended cleaner first

Barely damp, never wet

Mop-Water Math: What Goes in the Bucket

Here is how the ratios translate, using a gallon of water as the measuring stick and Advanage's published prices.

Mix

Concentrate per gallon of water

Per 24-oz spray bottle

Cost per mixed gallon (gallon jug)

20:1 (tile and linoleum)

6.4 oz

about 1.1 oz

about $4.76

32:1 (lightest published mix)

4 oz

about 0.7 oz

about $3.03

From a 55-gallon drum, the same mixes cost about $1.47 and $0.93 per mixed gallon, which is why facilities that mop at volume buy that way. Our guide to whether cleaning concentrates are worth it shows the math behind choosing a size, and our commercial and industrial cleaning overview covers floors at business scale.

Why Floors Streak, and How to Fix It

Most floor problems trace back to a short list of causes. The flooring maker's own guides name one of them directly: leftover residue forms a dull film.

What you see

Likely cause

Fix

Cloudy film or dull patches

Too much concentrate, or no rinse pass

Measure with an applicator, drop to a lighter mix, and run a clean-water pass

Streaks near edges and doorways

A dirty pad or dirty mop water

Swap to a fresh pad every room or two, and refill the bucket when the water looks gray

Sticky or tacky feel

Residue left behind

Mop once with clean water, wring well, then dry with a clean microfiber cloth

Water spots near sinks and entries

Pooled water drying on its own

Dry edges and thresholds as you go

The Microfiber Mop Method, Step by Step

A flat microfiber mop is the most forgiving tool for floors, because it holds only a little liquid and lifts dirt instead of pushing it around. The Microfiber Mop & High Duster Cleaning Set is $59.95 and includes a microfiber mop with an aluminum telescopic handle and a swivel head, a High Duster for high shelves and hard-to-reach spots, and two heavy-duty microfiber towels. Advanage describes the mop as working wet or dry on kitchen floors, tile and hardwood, and as more effective than disposable pads and better than sponge mops.

  1. Sweep or vacuum first. Use a hard-floor setting and skip any beater bar. Grit scratches finishes, and mopping over it just moves it around.

  2. Measure your mix. Add water to a bucket or a spray bottle, then add the concentrate using the ratios above.

  3. Test a hidden spot. Try the mix in a closet corner or under a rug, wait a few minutes, and wipe it dry.

  4. Dampen the pad, not the floor. Mist the pad or dip and wring it until it is barely damp. Never pour liquid directly onto the floor.

  5. Mop in sections. Work along the length of the planks or tile in small areas, rinsing the pad as it picks up soil.

  6. Rinse where the chart calls for it. On tile and linoleum, Advanage's chart says to rinse after cleaning, so follow with a clean, damp pass.

  7. Dry the edges. Finish with a microfiber cloth along walls, thresholds, and the base of cabinets.

If you want to see mixing and applying in action, Advanage's Cleaning Videos show the technique.

Why Lavender for Floor Day

All four ADVANAGE 20X scents clean the same way, so choosing Lavender is a scent decision. It leaves a gentle floral note that many people like in bedrooms, hallways, and living areas, and the Lavender Starter Kit is listed as a floor-cleaner kit with a free mixing applicator for $39.95. If you prefer no scent at all, the fragrance-free Clear/Odorless gallon uses the same concentrate. The Lavender concentrate is dyed purple, so test it in a hidden spot before using it on pale grout or very light flooring.

If kids or pets spend time on the floor, our guides to pet-safe and child-safe cleaning and the best non-toxic all-purpose cleaner cover what to look for. To see exactly what is in the bottle, our explainer on ingredients and safety data sheets walks through it. And if someone in the household has been sick, our look at how cleaning and disinfecting differ explains what to add after you mop.

Common Questions

What is the best way to mop vinyl plank flooring?

Sweep or vacuum first, then use a barely damp microfiber mop and a cleaner your floor's maker approves. Armstrong's care instructions recommend damp mopping with an electrostatic mop or a robot mop using a pH-neutral cleaner at recommended dosages. Steam mops and pooled water are the usual causes of damage. Engineered Floors adds that vinegar, "mop and shine" products, soap-based detergents, oil soaps, abrasive cleaners, and floor wax should stay off vinyl. Plain warm water on a microfiber mop is a safe baseline for light cleaning.

What is the best way to make a cleaning solution for vinyl plank floors?

Start with what your floor maker recommends and follow its label dosage exactly. If your maker's guide allows a general cleaner and you want to try ADVANAGE 20X, test a hidden spot first and begin at 32:1, which is about 4 ounces of concentrate to a gallon of water. Mix by measure, apply it to the pad, and finish with a clean, damp pass so nothing is left on the surface. If the test spot looks dull or feels tacky, stop and use your maker's cleaner instead.

How much should I dilute floor cleaner?

Follow the label ratio on the product you are using, because more concentrate does not clean better and often leaves a film that attracts dirt. For ADVANAGE 20X, the published floor mix is 20:1 for tile and linoleum, and 32:1 is the lightest mix on the chart. Convert ratios to ounces so every refill is the same: 20:1 is 6.4 ounces per gallon of water, and 32:1 is 4 ounces. Use lukewarm water, never mix two cleaners together, and drop to a lighter mix if you notice haze.

How do I make mop solution for laminate floors?

Laminate hates standing water, so the solution matters less than how wet the mop is. Use a cleaner your laminate maker approves, and note that one flooring guide advises against soaps, one-step floor products, abrasives, polishes, and wax, and says to dry the floor thoroughly after damp cleaning. If your maker's guide allows a general cleaner, test first, then mist a 32:1 mix onto the pad rather than the floor, wring the pad well, mop along the planks, and dry each section before moving on.

A Company That Makes Mopping Simple

ADVANAGE has made this concentrate since 1980, and its team can help you choose a mix and a starter size for your home. If you are unsure about a particular floor, you can contact Advanage directly before you start, and keep your flooring maker's care guide handy when you do.

Ready for mop day? Shop the Lavender Quart ($39.95) or the Lavender Gallon ($99.95), and add the Microfiber Mop & High Duster set ($59.95).

Frequently Asked Questions

What is the best way to mop vinyl plank flooring?

Sweep or vacuum first, then use a barely damp microfiber mop and a cleaner your floor's maker approves. Armstrong's care instructions recommend damp mopping with an electrostatic mop or a robot mop using a pH-neutral cleaner at recommended dosages. Steam mops and pooled water are the usual causes of damage. Engineered Floors adds that vinegar, "mop and shine" products, soap-based detergents, oil soaps, abrasive cleaners, and floor wax should stay off vinyl. Plain warm water on a microfiber mop is a safe baseline for light cleaning.

What is the best way to make a cleaning solution for vinyl plank floors?

Start with what your floor maker recommends and follow its label dosage exactly. If your maker's guide allows a general cleaner and you want to try ADVANAGE 20X, test a hidden spot first and begin at 32:1, which is about 4 ounces of concentrate to a gallon of water. Mix by measure, apply it to the pad, and finish with a clean, damp pass so nothing is left on the surface. If the test spot looks dull or feels tacky, stop and use your maker's cleaner instead.

How much should I dilute floor cleaner?

Follow the label ratio on the product you are using, because more concentrate does not clean better and often leaves a film that attracts dirt. For ADVANAGE 20X, the published floor mix is 20:1 for tile and linoleum, and 32:1 is the lightest mix on the chart. Convert ratios to ounces so every refill is the same: 20:1 is 6.4 ounces per gallon of water, and 32:1 is 4 ounces. Use lukewarm water, never mix two cleaners together, and drop to a lighter mix if you notice haze.

How do I make mop solution for laminate floors?

Laminate hates standing water, so the solution matters less than how wet the mop is. Use a cleaner your laminate maker approves, and note that one flooring guide advises against soaps, one-step floor products, abrasives, polishes, and wax, and says to dry the floor thoroughly after damp cleaning. If your maker's guide allows a general cleaner, test first, then mist a 32:1 mix onto the pad rather than the floor, wring the pad well, mop along the planks, and dry each section before moving on.

To top